ER-MIDI-THRU

Features

• Splits MIDI from input to 4 outputs
• Pairs nicely with ER-MIDI-CV4-02 card using stereo 3.5mm patch cable
• MIDI In on DIN-5 or 3.5mm TRS Type A
  • Can only plug in one at a time
  • MIDI spec uses 2.5mm jack but allows for other sizes such as 2.5mm
• 4 Channel MIDI outputs on 3.5mm TRS Type A
• MIDI Activity LED
  • ON when a MIDI packet is input
• Front Panel is 6 HP wide (30mm)
  • Daughtercard is 28mm wide for easy installation into rack
• 3U tall
• Eurorack 2x8 power jack
  • Uses 5V only

Connectors

J1 - MIDI In - TRS

J2-J5 - MIDI In - TRS

J6 - Eurorack Power

• 2x8 IDC connector
• Requires 5V power

J7 - MIDI In - DIN

Design

• MIDI In DIN

• MIDI In TRS-A

• MIDI Out TRS-A

Daughtercard

Reference Documents

• Deftaudio
  • TRS version
  • DIN version
• All you need to know about TRS MIDI connections

The SOURCE provides the power, whether 3.3v or 5v, to power an LED in the optocoupler in the receiving device, 
while the SINK pulls that power to ground whenever there is data to be transmitted. 

DIN MIDI Connector
In the good old DIN5 MIDI Connectors, 3 out of the 5 pins are used. Pin 2 is used as GROUND, 
Pin 4 is used as the current SOURCE, while Pin 5 is used as the current SINK. 

Type A 
The Type A TRS connection is the official standard adopted by the MIDI Association. The Tip is the Sink (pulls the data line down) and the Ring is the Source.

Assembly Sheet

• ER-MIDI-THRU Rev 1 Interactive BOM
• ER-MIDI-THRU Rev 1 Assembly Sheet