Difference between revisions of "TinySA"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 39: | Line 39: | ||
* Built | * Built | ||
** Standard 5% resistor values | ** Standard 5% resistor values | ||
| − | ** R2 = 2 paralleled 120 Ohm 1/4W resistors | + | ** R2 = 2 paralleled 120 Ohm 1/4W resistors = 60 ohms |
| − | ** R1 = | + | ** R1 = 510 in parallel with 8.2K = 247.3 ohms |
** Flat from 0-30 MHz | ** Flat from 0-30 MHz | ||
** Measured attenuation is flat | ** Measured attenuation is flat | ||
| − | *** - | + | *** -tbd dB at 1 MHz |
| − | *** - | + | *** -tbd4dB at 30 MHz |
| − | ** | + | ** tbd ohms, tbd nF |
| − | ** SWR | + | ** SWR tbd |
** 1/2W max (5V max, 0 ohm source) | ** 1/2W max (5V max, 0 ohm source) | ||
* LTSPICE Simulation | * LTSPICE Simulation | ||
Revision as of 03:07, 6 September 2021
Contents
TinySA - Spectrum Analyzer
- Maximum input level
- 0 dBm = 1 mW
- dBm = 10*LOG(milliwatts)
- -10 dBm = 0.1 mW
- +10dBm = 10 mW
- +20dBm = 1000 mW
- 3.3V at 50 Ohm = 0.2178W
- 217.8 mW = 23.4 dBm
- tinySA wiki
Attenuators
30 dB Attenuator
- Built
- Standard 5% resistor values
- R2 = 2 paralleled 120 Ohm 1/4W resistors paralleled with 470 ohms = 53.2 ohms
- R1 = 820 in parallel with 22K = 790.6 ohms
- Flat from 0-30 MHz
- Measured attenuation is flat
- -30.01dB at 1 MHz
- -30.24dB at 30 MHz
- 53.1 ohms, 21.3nF
- SWR 1.06
- 1/2W max (5V max, 0 ohm source)
- LTSPICE Simulation
20 dB Attenuator
- Built
- Standard 5% resistor values
- R2 = 2 paralleled 120 Ohm 1/4W resistors = 60 ohms
- R1 = 510 in parallel with 8.2K = 247.3 ohms
- Flat from 0-30 MHz
- Measured attenuation is flat
- -tbd dB at 1 MHz
- -tbd4dB at 30 MHz
- tbd ohms, tbd nF
- SWR tbd
- 1/2W max (5V max, 0 ohm source)
- LTSPICE Simulation
Videos
