Difference between revisions of "DRIVE50"

From Land Boards Wiki
Jump to navigation Jump to search
Line 50: Line 50:
 
Term High = OK
 
Term High = OK
 
</pre>
 
</pre>
 +
 +
* All 3 LEDs are on
  
 
== Mechanicals ==
 
== Mechanicals ==

Revision as of 15:54, 30 July 2022

DRIVE50 FRONT 3D.png

50 Ohm Driver Card

  • "TTL" Level Line driver
  • 50 or 75 Ohm output impedance
  • BNC or SMA output connector
  • 10K pull-up on input
  • Card is non-inverting
  • 1.5V-5.5V power
    • Typically 3.3V or 5V
  • 3-pin right angle 0.1" pitch input connector
  • (4) 4-40 mounting holes

Driver

  • 5x paralleled 74AC14 drivers
    • 24mA per pin max current output
      • Symmetric high-low drive levels
    • Short-circuit proof
      • 5V, 250 Ohms to ground is 20 mA (pins are rated for 24 mA
  • Card input has single buffer stage
  • Schmitt Trigger Input
  • 3.3V, 250 Ohm resistors (/5) for 50 Ohm output
    • Normal output = 10 mA per pin

Test

  • Supply Vcc 3.3V to 5V and ground
  • Input is pulled up to Vcc
  • Measure output with BNC T
    • Should be 1/2 of Vcc with 50 Ohm terminator
    • Should be Vcc without terminator

Automated Test Software

  • PulseGen_DRIVE50_Test.py - Tests PulseGen and DRIVE50 cards
  • Connect 3 pin power cable to card
  • Connect BNC T to output of card
  • Connect BNC female from tester to BNC T male
  • Install 50 terminator to other side of BNC T
  • Connect USB C cable
  • Display will show
PulseGen/DRIVE50 V1.1
50 Ohm card
Set/Got Low
Term High = OK
  • All 3 LEDs are on

Mechanicals

DRIVE50 MECHS REV1.PNG

Assembly Sheet