Editing ESP32-VGA

Jump to navigation Jump to search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.

Latest revision Your text
Line 416: Line 416:
  
 
* '''Rev 1 board won't program or boot with FDTI #2 card attached'''
 
* '''Rev 1 board won't program or boot with FDTI #2 card attached'''
** Earlier FabGL had GPIO12 instead of GPIO34
+
* Swap FTDI pins 4 and 5 (J2 and J6)
** Move FTDI Rx line (GPIO12 to GPIO34)
 
* Swap FTDI pins 4 and 5 (FTDI connectors)
 
 
** Allow direct connect to FTDI card (no swap)
 
** Allow direct connect to FTDI card (no swap)
 +
* Move FTDI Rx line (GPIO12 to GPIO34)
 +
** Earlier FabGL had previos connection
 
* Add SD Card connector
 
* Add SD Card connector
 
** MISO => GPIO 16
 
** MISO => GPIO 16
Line 426: Line 426:
 
** CS  => GPIO 13
 
** CS  => GPIO 13
 
** Remove I/O pins from GVS connector
 
** Remove I/O pins from GVS connector
* Replace H1/H2 with 1x2 to select/remove DC jack power\
+
* Replace H1/H2 with 1x2 to select/remove DC jack power
* Remove Polysilicone fuse
+
* Change ESP32 silkscreen
* Change ESP32 board name silkscreen
+
** SD card
* Add SD card connector
+
* VGA High/Low lines backwards on silkscreen
  
 
== Prototype ==
 
== Prototype ==

Please note that all contributions to Land Boards Wiki may be edited, altered, or removed by other contributors. If you do not want your writing to be edited mercilessly, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource (see Land Boards Wiki:Copyrights for details). Do not submit copyrighted work without permission!

Cancel Editing help (opens in new window)