Difference between revisions of "I2C-RPT-08"

From Land Boards Wiki
Jump to navigation Jump to search
Line 33: Line 33:
  
 
* [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_I2CRPT08 Github repo] - Driver code
 
* [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_I2CRPT08 Github repo] - Driver code
* [https://github.com/land-boards/lb-Arduino-Code/tree/master/LBCards/I2CRPT08 Github repo] - Example code
+
* [https://github.com/land-boards/lb-Arduino-Code/blob/master/LBCards/I2CRPT08/I2CIO8X8wMux/I2CIO8X8wMux.ino Github repo] - Example code
  
 
=== Programming Note ===
 
=== Programming Note ===

Revision as of 13:09, 1 August 2020

Tindie-mediums.png

I2C-RPT-08-X1-P218-720px.jpg

Features

  • I2C Hub / Repeater / Replicator / Multiplexer / De-multiplexer
    • PCA9548A
    • Eight I2C Ports
    • 100KHz/400KHz operation
  • Host port
    • Controlled via I2C
    • 3.3V or 5V host operation
  • 3.3V or 5V slave ports operation
  • Voltage translation between the ports
  • Ex: a Raspberry PI which runs 3.3V can control I2C devices which run at 5V
  • On-board termination resistors
  • 49x49mm form factor
  • 4 solid 4-40 mounting holes

Schematic

Drivers/Example Code

Programming Note

  • The mux chip allows multiple or single I2C ports to be written at the same time
    • To only enable one port at a time make sure you disable a channel after use or disable last channel used before enabling new channel

Testing

P963-cropped-720px.jpg

Issues

  • Silkscreen shows SCK, should be SCL

Assembly Sheet