I2C-RPT-08

From Land Boards Wiki
Jump to navigation Jump to search

Tindie-mediums.png

I2C-RPT-08-X1-P218-720px.jpg

Features

  • I2C Hub / Repeater / Replicator / Multiplexer / De-multiplexer
    • PCA9548A
    • Eight I2C Ports
    • 100KHz/400KHz operation
  • Host port
    • Controlled via I2C
    • 3.3V or 5V host operation
  • 3.3V or 5V slave ports operation
  • Voltage translation between the ports
  • Ex: a Raspberry PI which runs 3.3V can control I2C devices which run at 5V
  • On-board 2.2K termination resistors
  • 49x49mm form factor
  • 4 solid 4-40 mounting holes

Connectors

  • The connectors are 2x6 right angle 0.1" pitch headers
  • Two of the pins are for power to or from the I2C connector
  • The other four pins are for the I2C interface

H1-H8 - Power to/from I2C Connectors

  • Install shunt to power the I2C slave card from the I2C-RPT-08 Card
    • Default factory ships as installed to power external I2C interfaces from the card

I2C Connections

  1. GND
  2. 3.3V or 5V VCC (Power Out - if jumper 1-2 installed, Power in - if jumper 1-2 is not installed)
  3. SDA
  4. SCL (Board marked with SCK)

Schematic

Drivers/Example Code

Programming Note

  • The mux chip allows multiple or single I2C ports to be written at the same time
    • To only enable one port at a time make sure you disable a channel after use or disable last channel used before enabling new channel

Testing

P963-cropped-720px.jpg

Issues

  • Silkscreen shows SCK, should be SCL

Assembly Sheet