Editing RF-Amp

Jump to navigation Jump to search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.

Latest revision Your text
Line 245: Line 245:
 
** Measured output with scope - not clipped at 9 MHz
 
** Measured output with scope - not clipped at 9 MHz
 
*** Approx. 1Vpp input = +22.1 dBm gain which matches the S21 with the attenuator on the input
 
*** Approx. 1Vpp input = +22.1 dBm gain which matches the S21 with the attenuator on the input
*** Vpp = 12.4V with 50 Ω load resistor
+
*** Vpp = 12.4V with 50 Ohm load resistor
 
** Starts clipping at 7 Mhz and down
 
** Starts clipping at 7 Mhz and down
 
* Therefore, can measure input impedance at 9 MHz
 
* Therefore, can measure input impedance at 9 MHz

Please note that all contributions to Land Boards Wiki may be edited, altered, or removed by other contributors. If you do not want your writing to be edited mercilessly, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource (see Land Boards Wiki:Copyrights for details). Do not submit copyrighted work without permission!

Cancel Editing help (opens in new window)