Difference between revisions of "VFO-001"

From Land Boards Wiki
Jump to navigation Jump to search
Line 115: Line 115:
  
 
[[file:tinySA_VFO-001_10MHz-Signal_1MHz-to-300MHz.png]]
 
[[file:tinySA_VFO-001_10MHz-Signal_1MHz-to-300MHz.png]]
 +
 +
* Zoom into 10 MHz fundamental
 +
 +
[[file:tinySA_VFO-001_10MHz-Signal_Narrow-10MHz.png]]
  
 
== Videos ==
 
== Videos ==

Revision as of 13:01, 1 October 2021

VFO-001 P132-720px.jpg

Features

Schematic

VFO-001-SCHEMATIC-V2A.PNG

  • PWR* - connect only when no Mini-360 Buck Regulator is used
  • PD01 - Power Distribution card (not shown)

Build

  • BNC/Power Jack placement

VFO-001-Nibbler-BNCs Placement-720px.jpg

  • Rear panel BNCs and power jack

VFO-001-Rear Panel-720px.jpg

  • Drill holes and nibble out for OLED cutout
    • A bit rough
    • Better to undercut nibble and file to size

VFO-001-Nibbler-01-720px.jpg

  • OLED fitted

VFO-001-Nibbler-OLED-Fitted-720px.jpg

  • Final

VFO-001 P132-720px.jpg

Libraries/Example Code

Land Boards Code

VFO Menu

  • Set Step Size
    • 1Hz, 10 Hz, 100 Hz, 1KHz, 10KHz, 100 KHz, 1 MHz, 10 MHz
  • Set frequency
    • 10 MHz to 40 MHz in step size steps
  • Select VFO
    • VFO0, VFO1, VFO2
  • VFO On/Off
    • On, Off
  • Drive Level
    • 2 mA, 4 mA, 6 mA, 8 mA
  • Set Calibration Value
    • In step size steps (down to 1 Hz)
  • Save [power-on] defaults

Libraries used in this app

Other Si5351 Libraries

Calbration Using WWV

  • Good method that doesn't require a frequency counter
  • Tune via ear and S meter
  • Requires shortwave (or ham) receiver that can receive 5/10/15 MHz
  • Rough tune calibration factor on scope or frequency counter
  • Fine tune to 1 Hz using WWV
  • 15 MHz WWV midday has better resolution

Measurements

  • Channel CLK0
  • 10 Mhz
  • 30 dB external attenuator (gain set in tinySA to -30dB)
  • Scan 1MHz to 300MHz

TinySA VFO-001 10MHz-Signal 1MHz-to-300MHz.png

  • Zoom into 10 MHz fundamental

TinySA VFO-001 10MHz-Signal Narrow-10MHz.png

Videos