SYNTH-VCO-01

Features

• Build of Pico VCO by HAGIWO
• Digital Voltage Controlled Oscillator (VCO)
• Three modes: Wavefold, FM and AM
• PWM output with 2 pole low pass filter
• Each mode has eight built-in waveforms
• XIAO RP2040 CPU
• (5) Pushbuttons
  • Octave Up/Down
  • Mode Up/Down (Wavefold, FM and AM)
  • Push Timbre switches between 8 waveforms
• (2) Knobs
  • Freq fine adjust
  • Mod adjust
• Standard EuroRack 16 pin header
  • Supports 12V in with on-board 5V regulator
  • 5V regulator can be not installed if 5V is available on EuroRack connection
• Card is not a Eurorack card
  • Probably too deep, needs cabling
• (4) 6-32 mounting holes
  • Stacks with SYNTH-MIDI-CTL-01 card

XIAO RP2040 Pins

• Pin 1, GP26 = Vol/Oct, Analog In
• Pin 2, GP27 = Freq Pot, Analog In
• Pin 3, GP28 = Mod, Analog In
• Pin 4, GP29 = Mod Pot, Analog In
• Pin 5, GP6 = Timbre Pushbutton, select waveform type, Digital Input
• Pin 6, GP7 = Gate (optional), Digital Input
• Pin 8, GP1 = Octave Down, Digital Input
• Pin 9, GP2 = Audio Output, PWM out
• Pin 10, GP4 = Mode Down, Digital Input
• Pin 11, GP3 = Mode Up, Digital Input
• Pin 12 = +3.3V
• Pin 13 = GND
• Pin 14 = +5V

Software

• SYNTHVCO01 Arduino Code

Assembly Sheet

• SYNTH-VCO-01 Rev 1 Assembly Sheet