Difference between revisions of "VFO-001"

From Land Boards Wiki
Jump to navigation Jump to search
Line 1: Line 1:
'''This is a work in process - Gathering pieces.'''
+
[[File:VFO-001_P132-720px.jpg]]
 
 
[[File:VFO-001_P113-720PX.jpg]]
 
  
 
== Features ==
 
== Features ==

Revision as of 13:59, 24 October 2020

VFO-001 P132-720px.jpg

Features

Schematic

VFO-001-SCHEMATIC.PNG

Parts

Blue Pill Card

STM32F103C8T6-Blue-Pill-Pin-Layout.gif

  • 3.3V operation work without level shifters for I2C
    • OLED can run from 3.3V
    • Si5351 can only run from 3.3V
  • Used right angle headers and Dupont cables
  • Replaced BOOT 0,1 jumpers
    • Jumper on BOOT1
    • Switch on BOOT0 - easier to download code
  • Download via serial
  • Arduino IDE

128x32 OLED

Si5351 003 720px.jpg

OLED128x32.PNG

Arduino Library for OLED

U8G2_SSD1306_128X32_UNIVISION_F_HW_I2C u8g2(U8G2_R0, /* reset=*/ U8X8_PIN_NONE);   // STM32, Ebay OLED
  u8g2.setFont(u8g2_font_ncenB14_tr);
Hello World Code
U8G2_SSD1306_128X32_UNIVISION_F_HW_I2C u8g2(U8G2_R0, /* reset=*/ U8X8_PIN_NONE);   // STM32, Ebay OLED

void setup(void) {
  u8g2.begin();
}

void loop(void) {
  u8g2.clearBuffer();			// clear the internal memory
  u8g2.setFont(u8g2_font_ncenB08_tr);	// choose a suitable font
  u8g2.drawStr(0,10,"Hello World!");	// write something to the internal memory
  u8g2.sendBuffer();			// transfer internal memory to the display
  delay(1000);  
}

Rotary Encoder/Breakout Board

RotaryEncoderCAD.PNG


Si5351 004 720px.jpg

Si5351 Frequency Generator

Si5351 001 720px.jpg

VFO3.PNG

  • I2C Daisy-chain connector
  • 3 outputs
    • Tx
    • Rx (may not need to use separate output)
    • BFO - could be adjusted

Si5351 002 720px.jpg

Measurements

Libraries/Example Code

Videos