IR Sensor

From Land Boards Wiki
Jump to navigation Jump to search

Tindie-mediums.png

IRSensor-P752-720px.JPG

IR Sensor

File:IR-Front.png File:IR-Back.png

IR-horiz-top.png

This design consists of an Infrared Emitter and Infrared Receiver. The initial design was done with a http://www.radioshack.com/product/index.jsp?productId=2049723 Radio Shack P/N 276-142 which worked fairly well.

Using a 1M Ohm resistor as the Infrared Receiver bias value I got a nice voltage swing at various distances.

I didn't like the mismatch between the peak emitter (950mm) and received frequencies (850mm) and the cost of the Radio Shack solution is not cheap ($3.69) so I decided to look for new parts.

IR Emitter

LiteOn http://www.digikey.com/product-detail/en/HSDL-4261/516-1706-ND/724038 HSDL-4261

Infrared Emitters High Speed (LED), 5V, 45mW, 870nm, 26 Deg, T1-3/4 package (5mm)

Iforward	0.1	A	
Pdiss	0.190	W	at 20 deg C
Vf-typ	1.7	V	at 100 mA
Voltage	5	V	Reverse
Vres	3.3	V	across resistor(s)
Res	35	Ohms	
Resx2	82		R1,R2
ResX2/2	41		
Iactual	0.080	A	
Power	0.266	W	
Power/2	0.133	W	
Pow-res	0.25	W	
Safety fact	0.531	W/W	
Pwr-LED	0.137	W	
Safety factor	0.720	W/W	
IR Receiver
OSHRAM http://www.digikey.com/product-detail/en/SFH313FA/475-1080-ND/607289 SFH 313

Phototransistors NPN Phototransistor 70V 200mW 870nm

Irradiance units Ic units 10 mW/cm2 0.01 A 1 mW/cm2 0.001 A 0.01 mW/cm2 0.0001 A

Connector

J1 is a 4-pin 0.1" pitch header type of connector. The pinout is a modified GVS pinout.

Ground (Square pin) Voltage - Transmitter +5V Voltage - Receiver +5V Sensor Output

The purpose of having a separate transmitter and receiver voltage is two-fold. One it would allow the transmitter to be turned off and on conserving power and allowing for calibration at power-up. It needs to be noted that the drive current is greater than the current a microprocessor can directly drive.

The second purpose is to allow the analog reference voltage to be used for the receiver increasing noise immunity from the main power of the digital controller card(s).