RPI PSOC5
Contents
Raspberry Pi Clone
Features
- Raspberry Pi Electrical and Mechanical Compatible
- 40 pin GPIO connector
- Connects to all GPIO pins of the Raspberry Pi
- Programmable System on a Chip (PSoC)
- Cypress Semiconductor
- USB Micro connector
- Placed in the same location as a Raspberry Pi
- Provides 5V power
- 5V power is polyfuse protected
- 3.3V regulator
- 3.3V or 5V I/O
- H3 - Voltage Select Jumper
- On-board LED
- PSOC Pin 5.4
Connectors
J1 - USB Power Connector
- USB Micro B
H1 - 40 Pin GPIO Connector
- BCM pin numbers
- PSOC5 to BCM mapping
H2 - Programming header
- GND
- RESET*
- SWDCK
- SWDIO
H3 - Power Select connector
- 1-2 = 3.3V
- 2-3 = 5V
H4 - 3.3V GPIO connector
- 3.3V
- 3.3V
- 15.0
- 15.1
- 3.0
- 3.1
- 3.2
- 3.3
- 3.4
- 3.5
- 3.6
- 3.7
- 15.2
- 15.3
- GND
- GND
H5 = 3.3V or 5V GPIO connector
- VZ0
- VZ0
- 4.5
- 4.4
- 4.3
- 4.2
- 0.7
- 0.6
- 0.5
- 0.4
- 0.3
- 0.2
- 0.1
- 0.0
- 4.1
- 4.0
- 12.3
- 12.2
- GND
- GND
Raspberry Pi Mechanicals
Drivers/Source Code
Schematic
Factor Acceptance Test
- Raspberry Pi Test Station - tests itself
Equipment
- Unit Under Test
- RPI_PSOC5
- Host computer
- Connected via Micro-USB cable
- Running PuTTY
- 115,200 baud
- LED-32 - LED Test Card
- Cable set from UUT to LED-32
- Load UUT card with RPI_PSOC5_Serial_01 test software
