Difference between revisions of "Z80-MBC2 Build Notes"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
Line 21: | Line 21: | ||
* Was able to use [http://land-boards.com/blwiki/index.php?title=ATProgHead ATProgHead] running Arduino as ISP to burn bootloader but not program the code | * Was able to use [http://land-boards.com/blwiki/index.php?title=ATProgHead ATProgHead] running Arduino as ISP to burn bootloader but not program the code | ||
− | * Could not use any of my FTDI cards | + | * Could not use any of my FTDI cards for serial programming since they have RTS/CTS but not DTR |
− | ** Most programmer setups in Arduino work just fine | + | ** Most programmer setups in Arduino work just fine with RTS since both are usually pulled, but not the MightyCore |
+ | ** This is speculation as to why but I am able to program [[SCREWDUINO]] cards just fine | ||
* Used [https://www.aliexpress.com/af/tl866ii-plus.html?d=y&origin=n&SearchText=tl866ii+plus&catId=0&initiative_id=AS_20210723071810 TL866ii] to program ATMEGA32 fuses | * Used [https://www.aliexpress.com/af/tl866ii-plus.html?d=y&origin=n&SearchText=tl866ii+plus&catId=0&initiative_id=AS_20210723071810 TL866ii] to program ATMEGA32 fuses | ||
** Reference: [https://binaryupdates.com/setting-avr-fuse-bits/ Setting AVR Fuse Bits] | ** Reference: [https://binaryupdates.com/setting-avr-fuse-bits/ Setting AVR Fuse Bits] |
Revision as of 15:44, 23 July 2021
- ebay - bare PCB $8
- Arrived in a couple of days
Build Notes
- An Easy to Build Real Homemade Computer: Z80-MBC2! - Instructable was helpful
- Hackaday project with files
- Build took less than 2 hours
- Used mostly junk box parts
- Purchased alternate SRAM
- Forgot to buy SIP resistors - made my own
- Ref des are not top-bottom or left-right
- PDF Assembly drawing text is not searchable
- Struggled to find some of the resistors
- KiCad Gerbers
- 5mm LEDs fit into 3mm hole spacing
- I didn't have a 3mm Blue so I used 5mm
Programming THE ATMEGA32
- Was able to use ATProgHead running Arduino as ISP to burn bootloader but not program the code
- Could not use any of my FTDI cards for serial programming since they have RTS/CTS but not DTR
- Most programmer setups in Arduino work just fine with RTS since both are usually pulled, but not the MightyCore
- This is speculation as to why but I am able to program SCREWDUINO cards just fine
- Used TL866ii to program ATMEGA32 fuses
- Reference: Setting AVR Fuse Bits
- If you use the programmer defaults it sets the clock to 1 MHz which gives a serial port rate of 600 baud (told me I needed to fix the fuses).
Other
- Serial port marking correlated to the FTDI card end not referenced from card internal