Difference between revisions of "STM32"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 25: | Line 25: | ||
* FTDI connection to Blue Pill Hub FTDI connector | * FTDI connection to Blue Pill Hub FTDI connector | ||
| − | * Set Switch (or jumper) on Blue Pill module set towards center of card to download | + | * Set Boot0 Switch (or jumper) on Blue Pill module set towards center of card to download |
* In Arduino IDE, | * In Arduino IDE, | ||
** Tools | ** Tools | ||
Revision as of 21:16, 5 January 2020
Features
- STM32F103
- 72 MHz
- 64KB Flash
- 20 KB SRAM
- 3.3V
- 16 MHz
- 2x12-bit, A/D converter
- 7-channel DMA controller
- SPI, I2C, UART interfaces
- 7 timers
- MicroUSB
- Reset button
- Download jumper
- Replaced with a slide switch
- Power LED
- PC 13 LED
- SWD connector
- RTC crystal
Uploading Code
- FTDI connection to Blue Pill Hub FTDI connector
- Set Boot0 Switch (or jumper) on Blue Pill module set towards center of card to download
- In Arduino IDE,
- Tools
- Board "Generic..."
- Upload method: "Serial..."
- Port: [the comm port]
- Tools
- Upload code
- Takes a while
- Set Switch (or jumper) on Blue Pill module set towards edge of card to run
- Press reset button
Annotated
Mechanicals
Schematics
Boot Jumpers
