Difference between revisions of "Colpitts Crystal Oscillator"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
Line 68: | Line 68: | ||
* 5V Operation | * 5V Operation | ||
+ | * +4.3 dBm | ||
[[file:CP_Osc__4p43MHz_4_to_10MHz__5V_SMT_tinySA.PNG]] | [[file:CP_Osc__4p43MHz_4_to_10MHz__5V_SMT_tinySA.PNG]] |
Revision as of 16:20, 19 September 2021
Contents
Features
- Colpitts Crystal Oscillator
- Useful for binning crystals
- Hand select close values from a pile of crystals
- Useful for design of crystal filters
- Made from junk box parts
- (2) 2N3904 transistors
- Standard value 1/4W resistors
- Design from Experimental Methods in RF Design - Fig 7.69
- Built by others (W2AEW, IMSAIGuy, etc)
- Runs from 4V to >16V
- May run at higher voltages, didn't tempt fate
- 15mA with 4.44 MHz crystal at 12V
Tested With
- 4.433 MHz crystal - worked
- 16 MHz crystal - worked
- 27 MHz crystal - didn't work
Prototype
- Cut square PCB material for raised pads
- Build on single side Copper clad PCB material
- Large ground plane
Scope Caps
- UUT = 4.4433 MHz crystal
- 8 Digits Frequency Counter shows 4.432285 MHz
- Rigol DS1054Z - 50 MHz scope (100 MHz mod)
- UltraScope
- Waveform triangular
Prototype
SMT Build
tinySA Measurements of SMT Build
- SMT build
- 12V power
- 4.43 MHz crystal
- Measured +8.6dBm into 50 ohm load
- 40 dBm attenuator to protect tinySA
- 8 Digits Frequency Counter shows 4.432298 MHz
- 4 to 30 MHz scan
- Rich even and odd harmonic content
- -60 dBm down outside of harmonics
- 4 to 100 MHz
- 5V Operation
- +4.3 dBm
W2AEW Video
- Wes Haywood EMiRFD circuit