GPS Frequency Standard
Contents
Hardware V2
- NEO-7M GPS
- Arduino in a Box card
- Arduino Pro Mini
- 3.3V, 8 MHz
- OLED Display
- Display lock status, set frequency
- Rotary Encoder Frequency Selection
- Flexible Input power
- On-board DC/DC buck regulator allows 7-23V input
- Direct 7-9V input (USE VRAW jumper)
- 3.3V or 5V Arduino support
- Measured 12 mA with 9V input and 3.3V Arduino Pro Mini
- Arduino Pro Mini
- 100x70mm enclosure
Hardware V1
- NEO-7M GPS
- Blue Pill Arduino compatible
- OLED Frequency Display
- Rotary Encoder Frequency Selection
- 80x50mm enclosure
Videos
GPS
- GPS Satellite Positioning Module NEO7M UBLOX Satellite Positioning 51 SCM STM32
- Specifications:
- Working Voltage: 3.3v-5.0v
- Color: As Picture Shown
- Description:
- With micro USB interface, you can debug GPS module with ordinary phone data cable, no longer need to use USB-TTL and other tools.
- TTL interface is reserved to facilitate the use of USB-TTL or external microcontroller to control and receive GPS information.
- Ceramic antenna on module board, no GPS external antenna can be used to search for stars.
- Reserved SMA antenna interface, can use external antenna, star search ability is stronger.
OLED Display
Description
- OLED display, no need backlight, self-illumination.
- The display performance is better than the traditional LCD display, also lower consumption.
Specifications
- Driver IC: SSD1306
- Size: 0.91 inch OLED
- Resolution: 128 x 32
- Size: 38 * 12 mm
- Number of pins: 4 Pin
- Interface Type: IIC interface
- Display Color: White
- Operating temperature:-40 ~ 85 ℃
I2C Pin Out
- GND: Power Ground
- VCC: Power + (DC 3.3 ~5v)
- SCL: Clock Line
- SDA: Data Line
Enclosure
Reference Materials
- Design & Build a GPS locked Frequency Standard- Scullcom
- SIMPLE 10 MHZ GPS FREQUENCY STANDARD AND RF GENERATOR
- uses Arduino Nano as FTDI replacement
- An Arduino-based GPS Disciplined Oscillator
- An Arduino Version of Brooks Shera's GPSDO
- Simulating the Brooks Shera (W5OJM) GPSDO Algorithm
- Aluminum PCB Instrument Box Enclosure Electronic Project Case DIY 80x50x20mm