Difference between revisions of "6 Channel Relay Driver Card"

From Land Boards Wiki
Jump to navigation Jump to search
Line 41: Line 41:
  
 
=== Ultimate Relay Card Jumpers ===
 
=== Ultimate Relay Card Jumpers ===
 +
 +
* To switch band pass filters, use the jumper configuration shown below
  
 
[[file:jumpers-BPF.gif]]
 
[[file:jumpers-BPF.gif]]

Revision as of 09:20, 22 January 2022

RELAY DRVE P1981-720PX.jpg

Features

  • Drives Ultimate relay-switched LPF kit
    • Open collector to turn off relay
    • Drives low to turn on relay
    • Only turn on one output at a time
  • Inputs
    • 6 channels (5 used)
    • Active-high in to drive relay to on state
    • 3.3K to transistor base
      • 1 mA for 3.3V drive
      • 1.5 mA for 5V drive
  • Outputs
    • Open Collector outputs from 2N3904 NPN transistors
  • Power
    • 9-14V power in
    • 5V power out to power relays
    • DC jack
  • 36x37mm card
    • 3 PCBs for $11 from OshPark

Ultimate Relay Card

Ultimate Relay Card 5.jpg

Ultimate Relay Card Connections

  • RF output from the connections circled in yellow
    • An alternative is to cut the track from the SMA connector center pins and add a wire to connect it to the common bus track that runs horizontally across the board, finishing at the "RF" pad circled in yellow
  • The RF input is the RFI pin of the 2 x 5-pin header on the left of the board (same as in the Low Pass Filter kit usage)

SWITCHED FILTER Cuts.PNG

  • Jumpers

Ultimate Relay Card Jumpers

  • To switch band pass filters, use the jumper configuration shown below

Jumpers-BPF.gif

Connectors

J1 - Input Connector

RELAY DRVR J1.PNG

  1. N/C
  2. IN1
  3. IN2
  4. IN3
  5. IN4
  6. IN5
  7. IN6
  8. GND

J2 - Output Connector

RELAY DRVR J2.PNG

  1. GND
  2. OUT6
  3. OUT5
  4. OUT4
  5. OUT3
  6. OUT2
  7. OUT1
  8. 5V OUT

Power Connector

  • 7-14V input
  • Center positive

Control via VFO-003

  • VFO-003
    • Band select via menu option
  • J8 - Arduino P5-P9
  • Arduino pins
  1. Arduino D5 - 10M select
  2. Arduino D6 - 15M select
  3. Arduino D7 - 20M select
  4. Arduino D8 - 40M select
  5. Arduino D9 - 80M select
  6. Vcc
  7. GND
  8. GND

VFO-003 J8.PNG

Testing

  • Apply 9-12V to DC jack
  • Use LED w/ resistor on output to check 5V
  • One channel at a time
    • Pull up channel input to +5V
    • Check output with LED pulled up to +5V out

CAD

RELAY-DRV CAD.PNG