Difference between revisions of "ATProgHead"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 39: | Line 39: | ||
== Connectors == | == Connectors == | ||
| − | H1 - GVS Duino interconnect cable | + | === H1 - GVS Duino interconnect cable === |
| + | |||
The connector from the GVSDuino to the ATProgHead is: | The connector from the GVSDuino to the ATProgHead is: | ||
| − | ATProghead-X2-H1.PNG | + | [[File:ATProghead-X2-H1.PNG]] |
| + | |||
| + | === H2 - ISP Cable Connector === | ||
| − | |||
The ISP Connector pinout is: | The ISP Connector pinout is: | ||
| − | ATProghead-X2-H2.PNG | + | [[File:ATProghead-X2-H2.PNG]] |
| + | |||
| + | == Board Dimensions == | ||
| − | + | [[File:ATProghead-X2-PWB.PNG]] | |
| − | ATProghead-X2-PWB.PNG | ||
Revision as of 13:08, 10 January 2020
Contents
ATmel Programmer Head
Description
The ATmel Programming Head (ATProgHead) is used to program 28-pin and 8-pin Atmel (AVR) microprocessors.
Here is the ATProgHead installed on top of the GVSDuino (Rev X4 or higher) and a FTDI-USB-TTL card in a 3D printed case.
Features
ATProgHead board features include:
- Daughter card to the GVSDuino (Revision X4 or higher) and gets installed above the GVSDuino board
- Status LEDs
- PROG - Programming in progress
- ERR - Error while programming
- ALIV - Heartbeat
- On-board 16 MHz resonator
- Extended 12-pin ISP connector on bottom of board
- Separate 6-pin ISP header allows board to act as an ISP programmer
- The GVSDuino uses an FTDI-USB-TTL board for its USB host connection.
- ATProgHead supports ATMega328P, ATTiny85 and other Atmel AVR parts.
- Can be used to load bootloader onto factory fresh chips.
- Can be used to load sketches onto chips without the overhead of the bootloader.
- 28-pin ATMega328P socket has a Zero Insertion Force socket which allows for easier programming than standard sockets (no tools required).
- 8-pin DIP socket for ATTiny parts
- 100mm square form factor
- 4-40 mounting hardware
- 3D printed standoffs for spacing off GVSDuino card
Compatible Software
- The board is compatible with ArduinoISP running on the GVSDuino.
- Details on programming ATTiny85 parts can be found here.
- Our ATProgHead ArduinoISP code is here (for our X1 board which had LED sense reversed).
Connectors
H1 - GVS Duino interconnect cable
The connector from the GVSDuino to the ATProgHead is:
H2 - ISP Cable Connector
The ISP Connector pinout is:
Board Dimensions
