Difference between revisions of "ER-PROTO-02"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 26: | Line 26: | ||
[[file:ER-PROTO-02_JACKS.PNG]] | [[file:ER-PROTO-02_JACKS.PNG]] | ||
| + | |||
| + | * Jacks have resistors on Tip/Ring-Switch | ||
| + | ** Typically Tip = 0 Ohm jumper, Ring/Switch = Do Not Populate (DNP on schematic) | ||
=== Pots === | === Pots === | ||
[[file:ER-PROTO-02_POTS.PNG]] | [[file:ER-PROTO-02_POTS.PNG]] | ||
| + | |||
| + | * Pots have optional pull-up/pulldown jumper positions | ||
| + | ** Install jumpers if pots are used as controls voltages | ||
| + | ** Do not install jumpers if pots are used as volume control voltages | ||
== Examples == | == Examples == | ||
Revision as of 10:56, 24 November 2022
Features
- Eurorack Prototyping card set
- 6 HP wide (30mm) front panel
- 3U tall
- 0-6 POTS
- Series resistors on pot wiper
- All 3 pot pins brought to top header
- 0-6 Jacks
- Tip/ring brought to header near bottom
- Pots on top, jacks on bottom
- Easier to adjust pots without bumping into pots
- Pots more often accessed than jacks
- Large prototyping area
- +12V, -12V down board edges
- 5V/GND down center of card
- Bussed connections horizontally
- Front Panel with generic labels
- Cover with White on Black P-Touch labels
Controls Card - Jacks/Pots
Jacks
- Jacks have resistors on Tip/Ring-Switch
- Typically Tip = 0 Ohm jumper, Ring/Switch = Do Not Populate (DNP on schematic)
Pots
- Pots have optional pull-up/pulldown jumper positions
- Install jumpers if pots are used as controls voltages
- Do not install jumpers if pots are used as volume control voltages
