Difference between revisions of "NANO-BKOUT"

From Land Boards Wiki
Jump to navigation Jump to search
Line 33: Line 33:
 
* (4) 4-40 mounting holes for installation into enclosures
 
* (4) 4-40 mounting holes for installation into enclosures
 
* Rounded corners to allow card to be installed into enclosure corners
 
* Rounded corners to allow card to be installed into enclosure corners
 +
 +
== Connectors - Rev X1 ==
 +
 +
[[File:NANO-BKOUT-Conns.png]]
 +
 +
=== ISP Connector ===
 +
 +
# D12
 +
# +5V
 +
# D13
 +
# D11
 +
# RST*
 +
# GND
 +
 +
=== (H18) AREF Select Jumper ===
 +
 +
* 1-2 = External AREF (via shared power pins)
 +
* 2-3 = Use 5V as AREF = Factory position
  
 
== Testing ==
 
== Testing ==

Revision as of 14:20, 10 January 2020

Tindie-mediums.png

Arduino Nano Breakout card

This card breaks out a Arduino Nano (not supplied with NANO-BKOUT card) into GVS (Ground-Voltage-Signal) headers for easy connection to external sensors.

NANO-BKOUT-P1010078-800px.jpg

Features

  • Breakout card for the Arduino Nano
  • NANO (not supplied) is:
    • Inexpensive ($6-$7 US, $2.50 China), multiple sourced part
    • 5V, 16 MHz
    • Installs onto female header/removable
    • DC regulator
    • Microprocessor ATMega328 Comparable with Arduino UNO
    • Mini USB connector
    • Reset switch
  • NANO-BKOUT has
  • DC Power Jack
  • GVS connections for most digital/analog signals
    • Ground and power connections for each digital lines simplify power distribution to external functions such as sensors
  • Additional analog input signals (over the Arduino UNO)
  • ICSP (In-Circuit System Programmer) header
  • I2C header
  • Aref voltage selection header
  • Direct connection to MyMenu card
    • I2C Interface
    • D6 connection for interrupt line
    • Located in mirrored location on both boards to allow the MyMenu to mount to the rear
  • 49x49mm form factor
  • (4) 4-40 mounting holes for installation into enclosures
  • Rounded corners to allow card to be installed into enclosure corners

Connectors - Rev X1

NANO-BKOUT-Conns.png

ISP Connector

  1. D12
  2. +5V
  3. D13
  4. D11
  5. RST*
  6. GND

(H18) AREF Select Jumper

  • 1-2 = External AREF (via shared power pins)
  • 2-3 = Use 5V as AREF = Factory position

Testing

Assembly Sheet