Difference between revisions of "QRP Labs High Performance SDR Receiver"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 46: | Line 46: | ||
** From external Bandpass Filter Switch | ** From external Bandpass Filter Switch | ||
| − | == Receiver Module | + | == Receiver Module == |
| − | == Polyphase Module | + | == Polyphase Module == |
| − | == Bandpass Module | + | == Bandpass Module == |
== Build Issues == | == Build Issues == | ||
Revision as of 18:33, 20 November 2021
Contents
Features
- Three modules
- QRP Labs High Performance Receiver Module
- Direct Conversion Receiver
- Uses a Quadrature Sampling Detector (QSD), also known as a Tayloe Detector
- FST3253 Mixer is arranged as a double-balanced mixer for maximum performance
- Circuit to mute receiver during transmit
- Low noise LM4562 op-amps are used in instrumentation amplifier configuration to provide excellent common mode noise rejection
- The audio output of the module is isolated using two 600:600-ohm transformers to reduce or eliminate the ground loop problems which can easily occur in SDR systems
- The module is designed to directly drive a stereo input sound-card or with a polyphase filter card
- Receiver board has a socket for the standard QRP Labs Band Pass Filter kit which can be routed to an external bandpass filter switch card
- The receiver requires a local oscillator (LO) input at 4x the receive frequency
- Using VFO-003 with 4x output option
- Receiver Build instructions
- QRP Labs Band Pass Filter
- Can be used with a Switched Bandpass filter board for multiband operation
- 10/15/20/40/80M QRP Labs Band Pass Filter Kits
- Band Pass Filter Build instructions
- QRP Labs Polyphase filter
- Polyphase network plug-in module kit which cancels the unwanted sideband and produces a single sideband (SSB) output
- Polyphase Filter Build instructions
- QRP Labs High Performance Receiver Module
- Band Pass Filter and Polyphase filter mount on Receiver Module
- Power supply
- Needs 5V supply
- Opamps can be powered from 5V or 12-14V (for higher dynamic range)
- The receiver module is sized 80 x 37mm
Silkscreen / Pinout
Pins
- IQ pins
- I, GND, Q outputs
- Power pins
- GND, +5V, +5V or +12V to +14V
- Tx Mute Input
- 5V mutes inputs
- LO input
- 3.3V from Si5351A oscillators
- IF input
- From external Bandpass Filter Switch
Receiver Module
Polyphase Module
Bandpass Module
Build Issues
- Transformers don't fit well and crowd parts around them
- QRP Labs polyphase module pics are for older revision card
Reference Documents
- Ultra Low Noise, High Performance, Zero IF Quadrature Product Detector and Preamplifier
- Understanding and Designing Sequence Asymmetric Polyphase Networks
- The double-tuned Circuit: An experimenter's tutorial
- 40/80m CW/SSB receiver
- Experimental Polyphase Receiver
- A Software Defined Radio for the Masses
- Very High Performance Image Rejecting Direct Conversion Receivers - NC2030 Radio
