Difference between revisions of "Slew Rate Controller on ER-PROTO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
Line 25: | Line 25: | ||
=== J6 - Eurorack Power Jack === | === J6 - Eurorack Power Jack === | ||
+ | * Install 14 pin socket for U1 | ||
+ | * Orient socket so Pins 1-7 face +12V bus (right side) | ||
+ | * Add wire U1-4 to +12V | ||
+ | * Add wire U1-11 to -12V | ||
* Install 10 pin jack at J6 | * Install 10 pin jack at J6 | ||
+ | ** Pin 1 to "STRIPE" | ||
[[file:ER-PROTO-01_SLEW_EURORACK_PWR_J6_.PNG]] | [[file:ER-PROTO-01_SLEW_EURORACK_PWR_J6_.PNG]] |
Revision as of 21:14, 12 November 2022
Contents
Features
- Simple dual slew rate limiter
- Used for portamento effects or to smooth out a stepped voltage from a sequencer, or for general audio or CV smoothing
- Each channel contains a buffer with 100K input impedance suitable for pitch CVs
- The slew pot affects the charging of a large capacitor connected to a second amplifier
- The second amp provides buffering for output to isolate the output jack from the actual slewing function
- Control range of 0-10s (approx.)
- Power: +12V @ 5mA, -12V @ 5mA
Credits
Jacks/Controls
- 2 Slew Rate adjustment Pots
- 4 Jacks
- 2 Input jacks
- 2 Output jacks
Wiring
J6 - Eurorack Power Jack
- Install 14 pin socket for U1
- Orient socket so Pins 1-7 face +12V bus (right side)
- Add wire U1-4 to +12V
- Add wire U1-11 to -12V
- Install 10 pin jack at J6
- Pin 1 to "STRIPE"
Jacks on Controls Card
- Install J1-J4
- Add wire J1-S to J3-S
- Add wire J3-S to J4-S
- Add wire J2-S to J4-S
Pots on Controls Card
- Install 100 Ohms resistor at R1, R2
- Install B100K at RV1, RV2
- Add wire RV1-1 to RV1-2
- Add wire RV2-1 to RV2-2
Input Buffers
- Node: J1-T, 100 Ohm J38-8 to open row
- Install 100K J1-T open row to another open row
- Node: J2-T, 100 Ohm J38-4 to open row
- Install 100K J1-T open row to another open row
Output Buffers
Video