Difference between revisions of "WA3TFS SDR Upverter Design"

From Land Boards Wiki
Jump to navigation Jump to search
Line 20: Line 20:
  
 
=== Pass Filter ===
 
=== Pass Filter ===
 +
 +
[[file:WA3TFS_Upverter_Inductor.PNG]]
  
 
[[file:WA3TFS_Upverter_Pass_Filter.PNG]]
 
[[file:WA3TFS_Upverter_Pass_Filter.PNG]]

Revision as of 13:23, 14 October 2021

WA3TFS Upverter-720px.jpg

Features

SDR up-converter/receiver shifts low frequencies up by 100 MHz. Used to listen to HF frequencies on an inexpensive RTL-SDR module.

Schematic

WA3TFS Upverter Schematic.PNG

Pass Filter

WA3TFS Upverter Inductor.PNG

WA3TFS Upverter Pass Filter.PNG

Software

Build

  • Nice silver mica caps
    • My kit was missing the center cap of the band filter (150 pF)
  • SBL-1 mixer
  • 30pF cap installed in J_A to J_B marked 300
  • Build was tough due to very small pads on the PCB
    • Particularly tough to solder ground pads
    • Pad shapes were not round so less area to set soldering iron
  • Pin 1 orientations on the mixer and oscillator "backwards" from other board legends
    • Pin 1 shown in red

WA3TFS Upverter pcb r11.jpg

Wiring

WA3TFS Upverter Wiring.PNG

Enclosure

Adafruit 2230-00.jpg

2230-03.jpg

Videos by others