PiPicoMite01 Rev1 Assembly Sheet

• Make sure you build with the current revision assembly sheet
  • Revision is marked on the rear of the card
• PiPicoMite01 Rev2 Assembly Sheet

Parts List

Find	Qty	Ref Des	Part Number		Find	Qty	Ref Des	Part Number
1	1	U3	TXS0104EDR or TXS0104ED		15	1	J1	Header, Vert, 1x2
2	6	R1, R2, R10, R11, R13, R14	2.2K (1/8W)		16	1	J4	Header, Vert, 2x3
3	2	R3, R4	270 (1/8W)		17	1	J6	Header, Vert, 2x8
4	1	R5	390 (1/8W)		18	1	J9	Header, Vert, 2x10
5	2	R6, R8	47 (1/8W)		19	1	J11	Header, Rt Angle, 1x4
6	1	R7	820 (1/8W)		20	1	H1	Header, Vert, 2x2
7	2	R9, R12	1K (1/8W)		21	2	J3, J5	Header, Female. 1x20
8	2	R15, R16	10K (1/8W)		22	1	J7	AudioJack3, SJ1-3523N Mouser
9	4	C1-C4	0.1uF		23	1	J8	PS2_DIN6 ebay
10	2	C5, C6	47nF		24	1	J10	CONN, DB15HD, BLUE (VGA) Mouser
11	2	C7, C8	47uF		25	1	J2	USB-B Mouser
12	1	D1	1N5819 Mouser		26	1	U1	Raspberry Pi Pico Digikey Adafruit
13	1	D2 (alt for D1)	MBR0520T1H		27	1	U2	MCP23017_SP Adafruit
14	1	SD1	Conn, SD Card Mouser

Notes

1. Install either D1 or D2
2. Can use 1N400x in place of Schottky diode at D1/D2 location
3. DC can be provided via header pins on J4 so J2 (USB B power connector) can be omitted
4. U2 socket is optional
5. Install shunts at H1, J2 as required per wiki page
6. Resistor pads fit either 1/8W or 1/4W parts (1/4W shown here)

I2C connections to MCP23017 - Rework

• SDA, SCL swapped to MCP23017
• Cut etch solder side Pico pin 19 (to U2-12)
• Cut etch solder side Pico pin 20 (to U2-13)
• Cuts are done on rear side (CAD)
• Verify cuts with ohmmeter

• Cuts shown on board (using sharp Xacto knife)

• Jumpers
• Add wire Pico pin 19 to U2-13 (GP14)
• Add wire Pico pin 20 to U2-12 (GP15)
• Glue down wires with small dots of Superglue