Difference between revisions of "Frequency Calibration via GPS"

From Land Boards Wiki
Jump to navigation Jump to search
Line 12: Line 12:
  
 
=== GPS ===
 
=== GPS ===
 +
 +
* U-Blox NEO-7M GPS Module
 +
** Programmable frequency from USB
 +
* SMA Female connector
 +
* 5V operation
  
 
[[File:NEO-7M-02.PNG]]
 
[[File:NEO-7M-02.PNG]]
Line 18: Line 23:
  
 
[[File:NEO-7M-05.PNG]]
 
[[File:NEO-7M-05.PNG]]
 
* U-Blox NEO-7M GPS Module
 
* SMA Female connector
 
  
 
==== U-Center Programming Software ====
 
==== U-Center Programming Software ====
  
 +
* TP5 sets PPS output to "any" frequency
 
* [https://www.u-blox.com/en U-Blox website]
 
* [https://www.u-blox.com/en U-Blox website]
 
** [https://www.u-blox.com/en/product/u-center U-Center software]
 
** [https://www.u-blox.com/en/product/u-center U-Center software]
 
* Set to 8 MHz on GPS PPS pin when locked
 
* Set to 8 MHz on GPS PPS pin when locked
** Other frequencies have some "jitter"
+
** Other frequencies have some "jitter" but are still GPS accurate
 
* Set to 2 Hz on GPS PPS pin when not locked
 
* Set to 2 Hz on GPS PPS pin when not locked
  

Revision as of 11:19, 22 December 2020

Inexpensive Frequency Standard with output synchronized to GPS satellites,

Features

  • Generates very accurate frequency output
  • U-Blox NEO-7M GPS Module
  • Remote Amplified GPS Antenna
  • FTDI-49MM
  • 50 Ohm Output

Parts

GPS

  • U-Blox NEO-7M GPS Module
    • Programmable frequency from USB
  • SMA Female connector
  • 5V operation

NEO-7M-02.PNG

NEO-7M-04.PNG

NEO-7M-05.PNG

U-Center Programming Software

  • TP5 sets PPS output to "any" frequency
  • U-Blox website
  • Set to 8 MHz on GPS PPS pin when locked
    • Other frequencies have some "jitter" but are still GPS accurate
  • Set to 2 Hz on GPS PPS pin when not locked

FTDI

50 Ohm Driver (Not Required - nice to have)

  • Used modified PulseGen card to drive 50 Ohms, 5V level output
    • Remove oscillator circuit
    • 5 parallel 74AC14 outputs with 249 ohm resistors on each output
  • Able to drive long 50 ohm coax
  • Square wave output
  • Very fast edges

Videos

  • This is the approach I followed

  • GPSDO vs Rubidium Frequency Standard