View source for NANO-BKOUT

[[File:tindie-mediums.png|link=https://www.tindie.com/products/land_boards/nano-breakout-card/]]

== Arduino Nano Breakout card ==

This card breaks out a Arduino Nano (not supplied with NANO-BKOUT card) into GVS (Ground-Voltage-Signal) headers for easy connection to external sensors.

[[File:NANO-BKOUT-P1010078-800px.jpg]]

== Features ==

* Breakout card for the Arduino Nano
* NANO (not supplied) is:
** Inexpensive ($6-$7 US, $2.50 China), multiple sourced part
** 5V, 16 MHz
** Installs onto female header/removable
** DC regulator
** Microprocessor ATMega328 Comparable with Arduino UNO
** Mini USB connector
** Reset switch
* NANO-BKOUT has
* DC Power Jack
* GVS connections for most digital/analog signals
** Ground and power connections for each digital lines simplify power distribution to external functions such as sensors
* Additional analog input signals (over the Arduino UNO)
* ICSP (In-Circuit System Programmer) header
* I2C header
* Aref voltage selection header
* Direct connection to MyMenu card
** I2C Interface
** D6 connection for interrupt line
** Located in mirrored location on both boards to allow the MyMenu to mount to the rear
* 49x49mm form factor
* (4) 4-40 mounting holes for installation into enclosures
* Rounded corners to allow card to be installed into enclosure corners

== Connectors - Rev X1 ==

[[File:NANO-BKOUT-Conns.png]]

=== ISP Connector ===

# D12
# +5V
# D13
# D11
# RST*
# GND

=== (H18) AREF Select Jumper ===

* 1-2 = External AREF (via shared power pins)
* 2-3 = Use 5V as AREF = Factory position

== NANO-BKOUT Plus MyMenu ==

* NANO-BKOUT
* MyMenu

[[File:NanoMenu-LED-Front-P1010191-640px.jpg]]

[[File:NanoMenu-SideBack-P1010185-640px.jpg]]

[[File:NanoMenu-Back-P1010181-640px.jpg]]

== Testing ==

* [[Arduino Based Test Station]]
* [https://github.com/land-boards/lb-Arduino-Code/tree/master/LBCards/ODAS/ODASTESTER ODAS Tester Github Repo]

== Assembly Sheet ==

* [[Arduino Nano Breakout Card Assembly Sheet]]