Difference between revisions of "STM32"

From Land Boards Wiki
Jump to navigation Jump to search
Line 21: Line 21:
 
* SWD connector
 
* SWD connector
 
* RTC crystal
 
* RTC crystal
 +
 +
=== Uploading Code ===
 +
 +
* FTDI connection to Blue Pill Hub FTDI connector
 +
* Set Switch (or jumper) on Blue Pill module set towards center of card to download
 +
* In Arduino IDE,
 +
** Tools
 +
*** Board "Generic..."
 +
*** Upload method: "Serial..."
 +
*** Port: [the comm port]
 +
 +
[[File:ArduinoIDE_Tools_Menu.png]]
 +
 +
* Upload code
 +
** Takes a while
 +
* Set Switch (or jumper) on Blue Pill module set towards edge of card to run
 +
* Press reset button
  
 
== Annotated ==
 
== Annotated ==

Revision as of 21:08, 5 January 2020

BluePill-P642-cropped-720px.jpg

Features

  • STM32F103
    • 72 MHz
    • 64KB Flash
    • 20 KB SRAM
    • 3.3V
    • 16 MHz
    • 2x12-bit, A/D converter
    • 7-channel DMA controller
    • SPI, I2C, UART interfaces
    • 7 timers
  • MicroUSB
  • Reset button
  • Download jumper
    • Replaced with a slide switch
  • Power LED
  • PC 13 LED
  • SWD connector
  • RTC crystal

Uploading Code

  • FTDI connection to Blue Pill Hub FTDI connector
  • Set Switch (or jumper) on Blue Pill module set towards center of card to download
  • In Arduino IDE,
    • Tools
      • Board "Generic..."
      • Upload method: "Serial..."
      • Port: [the comm port]

ArduinoIDE Tools Menu.png

  • Upload code
    • Takes a while
  • Set Switch (or jumper) on Blue Pill module set towards edge of card to run
  • Press reset button

Annotated

STM32-Annotated.jpg

Mechanicals

STM32-Mechanicals-2.jpg

Schematics

STM32-Schematic.jpg

Boot Jumpers

BootJumpers.PNG