Difference between revisions of "ER-PROTO-01"

Revision as of 19:22, 6 November 2022

Eurorack Prototyping card set
6 HP wide (30mm) front panel
3U tall
Three card set
- Board interconnect headers duplicated on headers
- 30mm wide front panel
- 28mm wide panel and daughtercards
6 POTS
- Marked as RV1-RV5
- Series resistors on pot wiper
- All 3 pot pins brought to top header
4 Jacks
- Marked as J1-J4
- Tip/sleeve brought to header near middle/bottom
Pots on top, jacks on bottom of card
- Easier to adjust pots without bumping into pots
- Pots more often accessed than jacks
Large prototyping area
- 58 nodes with 3 holes per node (29 per "side")
+12V, -12V down board edges
5V/GND down center of card
Bussed connections horizontally
Front Panel with generic labels
- Cover with White on Black P-Touch labels

J5 on the Controls card and J5 on the I/O card
Pot connections
- POTx-1 is fully CW connects to wiper
- POTx-2 is wiper
- POTX-3 is fully CCW connects to wiper
To make pot into voltage control
- CW = +5V
- CCW = GND
- Wire RV1-1 to RV3-1 to RV5-1 on controls card
- Wire RV1-3 to RV3-3 to RV5-3 on controls card
- Wire RV2-1 to RV4-1 to RV6-1 on controls card
- Wire RV2-3 to RV4-3 to RV6-3 on controls card

@@ Line 37: / Line 37: @@
 * J5 on the Controls card and J5 on the I/O card
-* POTx-1 is fully CW connects to wiper
+* Pot connections
-* POTx-2 is wiper
+** POTx-1 is fully CW connects to wiper
-* POTX-3 is fully CCW connects to wiper
+** POTx-2 is wiper
+** POTX-3 is fully CCW connects to wiper
+* To make pot into voltage control
+** CW = +5V
+** CCW = GND
+** Wire RV1-1 to RV3-1 to RV5-1 on controls card
+** Wire RV1-3 to RV3-3 to RV5-3 on controls card
+** Wire RV2-1 to RV4-1 to RV6-1 on controls card
+** Wire RV2-3 to RV4-3 to RV6-3 on controls card
 [[file:ER-PROTO-CTLS-6-01_J5.PNG]]