Difference between revisions of "ER-PROTO-02"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 58: | Line 58: | ||
=== Prototyping Daughtercard === | === Prototyping Daughtercard === | ||
| − | ==== | + | ==== J8, J28 - Pot connections ==== |
[[file:ER-PROTO2-DB_J8_J28.PNG]] | [[file:ER-PROTO2-DB_J8_J28.PNG]] | ||
| − | ==== | + | ==== J7, J29 - Jack connections ==== |
[[file:ER-PROTO2-DB_J7_J29.PNG]] | [[file:ER-PROTO2-DB_J7_J29.PNG]] | ||
| − | ==== ==== | + | ==== J9 - Eurorack Power ==== |
[[file:ER-PROTO2-DB_J9.PNG]] | [[file:ER-PROTO2-DB_J9.PNG]] | ||
| + | |||
| + | * Cand install 2x8 or 2x5 IDC box header | ||
== Examples == | == Examples == | ||
Revision as of 11:22, 24 November 2022
Contents
Features
- Eurorack Prototyping card set
- 6 HP wide (30mm) front panel
- 3U tall
- 0-6 POTS
- Series resistors on pot wiper
- All 3 pot pins brought to top header
- 0-6 Jacks
- Tip/ring brought to header near bottom
- Pots on top, jacks on bottom
- Easier to adjust pots without bumping into pots
- Pots more often accessed than jacks
- Large prototyping area
- +12V, -12V down board edges
- 5V/GND down center of card
- Bussed connections horizontally
- Front Panel with generic labels
- Cover with White on Black P-Touch labels
Jacks/Headers/Pots
Controls Card - Jacks/Headers/Pots
- 0-6 Jacks
- 0-6 Pots
- Headers to connect to Prototyping card
J1-J6 Jacks
- Jacks have resistors on Tip/Ring-Switch
- Typically Tip = 0 Ohm jumper, Ring/Switch = Do Not Populate (DNP on schematic)
J7 Header
- 2x8 female header
J8 Header
- 2x10 female headers
Pots
- Pots have optional pull-up/pulldown jumper positions
- Install jumpers if pots are used as controls voltages
- Do not install jumpers if pots are used as volume control voltages
Prototyping Daughtercard
J8, J28 - Pot connections
J7, J29 - Jack connections
J9 - Eurorack Power
- Cand install 2x8 or 2x5 IDC box header
