Difference between revisions of "Frequency Calibration via GPS"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) (→Parts) |
Blwikiadmin (talk | contribs) |
||
| Line 22: | Line 22: | ||
==== U-Center Programming Software ==== | ==== U-Center Programming Software ==== | ||
| − | ** Set to 8 MHz on GPS PPS pin when locked | + | * [https://www.u-blox.com/en U-Blox website] |
| − | + | ** [https://www.u-blox.com/en/product/u-center U-Center software] | |
| + | * Set to 8 MHz on GPS PPS pin when locked | ||
| + | * Set to 2 Hz on GPS PPS pin when not locked | ||
=== FTDI === | === FTDI === | ||
Revision as of 13:47, 28 November 2020
8 Mhz Output synchronized to GPS satellites
Contents
Features
- U-Blox NEO-7M GPS Module
- Remote Amplified GPS Antenna
- SMA Male connector
- FTDI-49MM
- Used to program the GPS module
- Pulse Generator modified to provide 50 Ohms, 5V drive
- Mini-360 Switching Power Supply
- 5V out
- 7-23V in
Parts
GPS
- U-Blox NEO-7M GPS Module
- SMA Female connector
U-Center Programming Software
- U-Blox website
- Set to 8 MHz on GPS PPS pin when locked
- Set to 2 Hz on GPS PPS pin when not locked
FTDI
50 Ohm Driver
- Used modified PulseGen card to drive 50 Ohms, 5V level output
Videos
