Difference between revisions of "Frequency Calibration via GPS"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 8: | Line 8: | ||
* [[FTDI-49MM]] | * [[FTDI-49MM]] | ||
* 50 Ohm Output | * 50 Ohm Output | ||
| − | |||
| − | |||
| − | |||
== Parts == | == Parts == | ||
Revision as of 11:12, 22 December 2020
Inexpensive Frequency Standard with output synchronized to GPS satellites,
Contents
Features
- Generates very accurate frequency output
- U-Blox NEO-7M GPS Module
- Remote Amplified GPS Antenna
- FTDI-49MM
- 50 Ohm Output
Parts
GPS
- U-Blox NEO-7M GPS Module
- SMA Female connector
U-Center Programming Software
- U-Blox website
- Set to 8 MHz on GPS PPS pin when locked
- Other frequencies have some "jitter"
- Set to 2 Hz on GPS PPS pin when not locked
FTDI
50 Ohm Driver (Not Required - nice to have)
- Used modified PulseGen card to drive 50 Ohms, 5V level output
- Remove oscillator circuit
- 5 parallel 74AC14 outputs with 249 ohm resistors on each output
- Able to drive long 50 ohm coax
- Square wave output
- Very fast edges
Videos
- This is the approach I followed
- GPSDO vs Rubidium Frequency Standard
