Difference between revisions of "DIGIO32-I2C"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 23: | Line 23: | ||
== Schematic == | == Schematic == | ||
| − | [Schematic] | + | * [land-boards.com/DIGIO32-I2C/DigIO32-I2C_X3_Schematic.pdf DIGIO32-I2C Schematic] |
== Drivers == | == Drivers == | ||
Revision as of 16:37, 1 January 2020
Features
- 32-bit Digital I/O
- Two MCP23017 16-bit I2C I/O Expanders
- EEPROM for board ID and application specific information
- Write Enable jumper protects EEPROM against accidental damage
- I/O Connector is inexpensive/standard DB-37
- I2C Interface
- Daisy-chain I2C connector
- I2C Termination jumpers for end of I2C chain
- I2C Address select jumper (2 addresses - can support up to 4 cards)
- Power Options
- Supports 3.3V or 5V signal levels
- Fuse protected power output on DB-37
- Power connector (not required for minimal loads
- ODAS form factor (width is 95 mm)
- 6-32 Mounting holes
Connectors
Schematic
- [land-boards.com/DIGIO32-I2C/DigIO32-I2C_X3_Schematic.pdf DIGIO32-I2C Schematic]
Drivers
- GitHub repo for the DigIO32-I2C Card Arduino library
