Difference between revisions of "WA3TFS SDR Upverter Design"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
| + | == Features == | ||
| + | |||
* SDR up-converter/receiver shifts low frequencies up by 100 MHz | * SDR up-converter/receiver shifts low frequencies up by 100 MHz | ||
** Used to listen to HF frequencies on an inexpensive RTL-SDR module | ** Used to listen to HF frequencies on an inexpensive RTL-SDR module | ||
Revision as of 12:16, 14 October 2021
Contents
Features
- SDR up-converter/receiver shifts low frequencies up by 100 MHz
- Used to listen to HF frequencies on an inexpensive RTL-SDR module
- 1 kHz to 1.7 GHz SDR Receiver - WA3TFS Design
Software
Enclosure
- Board fits perfectly in
Build
- Nice silver mica caps
- Real SBL-1 mixer
- Build was tough due to very small pads on the PCB
- Particularly tough to solder ground pads
- Pad shapes were not round so less area to set soldering iron
- Pin 1 orientations on the mixer and oscillator "backwards" from other board legends
- My kit was missing the center cap of the band filter (150 pF)
