Difference between revisions of "ER-PROTO-01"

Latest revision as of 17:48, 18 January 2023

Eurorack Prototyping card set
6 HP wide (30mm) front panel
3U tall
Three card set
- Board interconnect headers duplicated on headers
- 30mm wide front panel
- 28mm wide panel and daughtercards
6 POTS
- Marked as RV1-RV5
- Series resistors on pot wiper
- All 3 pot pins brought to top header
4 Jacks
- Marked as J1-J4
- Tip/sleeve brought to header near middle/bottom
Pots on top, jacks on bottom of card
- Easier to adjust pots without bumping into pots
- Pots more often accessed than jacks
Large prototyping area
- 58 nodes with 3 holes per node (29 per "side")
+12V, -12V down board edges
5V/GND down center of card
Bussed connections horizontally
Front Panel with generic labels
- Cover with White on Black P-Touch labels

J5 on the Controls card and J5 on the I/O card
Pot connections
- POTx-1 is fully CW connects to wiper
- POTx-2 is wiper
- POTX-3 is fully CCW connects to wiper

@@ Line 1: / Line 1: @@
+[[File:tindie-mediums.png|link=https://www.tindie.com/products/28599/]]
 [[FILE:ER-PROTO-PANEL-01-SET_FRONT_REAR-3D-720px.png]]
@@ Line 87: / Line 89: @@
 == Examples ==
-* Arduino NANO MOZZI
+=== Arduino NANO MOZZI ===
+[[Arduino NANO MOZZI on ER-PROTO-01]]
+[[file:ER-PROTO-01-NANO-MOZZI_P1080687-720PX.jpg]]
+[[file:ER-PROTO-01-NANO-MOZZI_P1080693-720PX.jpg]]
+=== CV4 - 4 Control Voltages ===
+[[ER-CVPOTS4]]
+[[file:ER-PROTO-01-CV4_P1090031-F_B_720px.jpg]]
+=== Noise Generator ===
+[[Noise_Generator_on_ER-PROTO-01|Noise Generator on ER-PROTO-01]]
+[[file:ER-PROTO-01_NOISE_P1080751-720px.jpg]]
+[[file:ER-PROTO-01_NOISE_P1080755-720px.jpg]]
+=== Slew Rate Controller ===
+[[Slew Rate Controller on ER-PROTO-01]]
-* Arduino NANO with quad Opamp example
+== Assembly Sheet ==
-[[file:ER-PROTO-DB-01_ARDUINO_NANO_OPAMP-720px.png]]
+* [[ER-PROTO-01 Assembly Sheet]]