Difference between revisions of "Noise Generator on ER-PROTO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
(93 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | * White Noise Generator | + | [[File:tindie-mediums.png|link=https://www.tindie.com/products/28599/]] |
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1090103-FR-B-720px.jpg]] | ||
+ | |||
+ | == Features == | ||
+ | |||
+ | * Eurorack 6HP, 3U module | ||
+ | * Noise Generator | ||
+ | ** Based on Moritz Klein's [https://www.youtube.com/watch?v=0yB_h_wFkh4 Designing a white, pink & blue noise generator from scratch] design | ||
+ | ** [https://en.wikipedia.org/wiki/Colors_of_noise White, Pink, Blue noise outputs] | ||
+ | ** Outputs are all buffered | ||
+ | * Built on [[ER-PROTO-01]] card | ||
+ | * 10 pin Eurorack power connector | ||
+ | |||
+ | === Noise Generator === | ||
+ | |||
+ | * Credit Moritz Klein's Designing a white, pink & blue noise generator from scratch design | ||
+ | |||
+ | <video type="youtube">0yB_h_wFkh4</video> | ||
+ | |||
+ | * Noise Generator | ||
+ | |||
+ | [[file:moritz_noise.PNG]] | ||
+ | |||
+ | * White/Pink/Blue noise | ||
+ | |||
+ | [[file:moritz_WHITE_PINK_BLUE.PNG]] | ||
+ | |||
+ | * High Pass Filter (Blue Noise) | ||
+ | |||
+ | [[file:moritz_HPF.PNG]] | ||
+ | |||
+ | * Low Pass Filter (Pink Noise) | ||
+ | |||
+ | [[file:moritz_LPF.PNG]] | ||
+ | |||
+ | == Build == | ||
+ | |||
+ | === White Noise Generator === | ||
+ | |||
+ | * Voltage Gain = 148 | ||
+ | * Switched from TL074 to TL084 | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_WHITE_Before.PNG]] | ||
+ | |||
+ | * Output seems pretty quiet (~200 mV) | ||
+ | ** Issue is 2N3904 is much quieter than a [https://www.mouser.com/ProductDetail/637-BC548B BC548] | ||
+ | ** Switched to [https://www.mouser.com/ProductDetail/637-BC548B BC548] | ||
+ | * Offset errors = about 500 mV | ||
+ | ** Gain = 148, 500mV = 3.5mV offset voltage | ||
+ | ** Add offset voltage trimmer | ||
+ | ** [https://electronics.stackexchange.com/questions/34071/how-do-i-correct-the-offset-voltage-of-op-amps-which-have-no-explicit-offset-nul Circuit from here] | ||
+ | |||
+ | [[file:OpAmp_Offset_Adj.PNG]] | ||
+ | |||
+ | * Schematic with offset | ||
[[file:ER-PROTO-01_NOISE_WHITE.PNG]] | [[file:ER-PROTO-01_NOISE_WHITE.PNG]] | ||
− | * Blue/Pink Noise | + | ==== White Noise Scopecaps ==== |
+ | |||
+ | * White Noise Scope capture | ||
+ | * 2 mS / div | ||
+ | |||
+ | [[file:White_Noise_Scope_Cap-01.png]] | ||
+ | |||
+ | * FFT, 25HKz range | ||
+ | |||
+ | [[file:FFT_White_Noise_25KHz.PNG]] | ||
+ | |||
+ | === Blue Noise Generator === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_BLUE.PNG]] | ||
+ | |||
+ | ==== Blue Noise Screencaps ==== | ||
+ | |||
+ | * FFT 1mS scope setting | ||
+ | |||
+ | [[file:FFT_Blue_J4_Noise_1mS.PNG]] | ||
+ | |||
+ | === Pink Noise Generator === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_PINK.PNG]] | ||
+ | |||
+ | === Pink Noise Scopecaps === | ||
+ | |||
+ | [[file:Pink_Noise_Scope_Cap.png]] | ||
+ | |||
+ | [[file:FFT_Pink_J4_Noise_1mS.PNG]] | ||
+ | |||
+ | === Pink Noise LTSpice === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_Pink_LTSpice.PNG]] | ||
+ | |||
+ | === Jacks === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_J38.PNG]] | ||
+ | |||
+ | == Connectors == | ||
+ | |||
+ | === J1 - White Output === | ||
+ | |||
+ | * +/- 7.5V swing | ||
+ | |||
+ | === J3 - Pink Output === | ||
+ | |||
+ | === J4 - Blue Output === | ||
+ | |||
+ | === Eurorack Power === | ||
+ | |||
+ | [[file:ER-PROTO-01_U1_PWR.PNG]] | ||
+ | |||
+ | == Build Details == | ||
+ | |||
+ | * Three card set | ||
+ | ** [[ER-PROTO-01]] Front Panel card | ||
+ | ** [[ER-PROTO-01]] Controls card | ||
+ | ** [[ER-PROTO-01]] Daughtercard | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1090115-720px.jpg]] | ||
+ | |||
+ | === On Controls Card === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1080760-JacksRework-720px.jpg]] | ||
+ | |||
+ | * Install J1, J3, J4 | ||
+ | * Wire J1-S to J3-S | ||
+ | * Wire J3-S to J4-S | ||
+ | |||
+ | === On Daughtercard === | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1090110-720px.jpg]] | ||
+ | |||
+ | * Transistor Noise Source wiring | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1090111-720px.jpg]] | ||
+ | |||
+ | * Opamp wiring | ||
+ | |||
+ | [[file:ER-PROTO-01_NOISE_P1090112-ANNOTATED-720PX.jpg]] | ||
+ | |||
+ | == References == | ||
− | [ | + | [https://www.schmitzbits.de/noise.html schmitzbits White Noise Source] |
Latest revision as of 18:51, 11 March 2023
Features
- Eurorack 6HP, 3U module
- Noise Generator
- Based on Moritz Klein's Designing a white, pink & blue noise generator from scratch design
- White, Pink, Blue noise outputs
- Outputs are all buffered
- Built on ER-PROTO-01 card
- 10 pin Eurorack power connector
Noise Generator
- Credit Moritz Klein's Designing a white, pink & blue noise generator from scratch design
- Noise Generator
- White/Pink/Blue noise
- High Pass Filter (Blue Noise)
- Low Pass Filter (Pink Noise)
Build
White Noise Generator
- Voltage Gain = 148
- Switched from TL074 to TL084
- Output seems pretty quiet (~200 mV)
- Offset errors = about 500 mV
- Gain = 148, 500mV = 3.5mV offset voltage
- Add offset voltage trimmer
- Circuit from here
- Schematic with offset
White Noise Scopecaps
- White Noise Scope capture
- 2 mS / div
- FFT, 25HKz range
Blue Noise Generator
Blue Noise Screencaps
- FFT 1mS scope setting
Pink Noise Generator
Pink Noise Scopecaps
Pink Noise LTSpice
Jacks
Connectors
J1 - White Output
- +/- 7.5V swing
J3 - Pink Output
J4 - Blue Output
Eurorack Power
Build Details
- Three card set
- ER-PROTO-01 Front Panel card
- ER-PROTO-01 Controls card
- ER-PROTO-01 Daughtercard
On Controls Card
- Install J1, J3, J4
- Wire J1-S to J3-S
- Wire J3-S to J4-S
On Daughtercard
- Transistor Noise Source wiring
- Opamp wiring