LED-32

Features

• 32 LEDs
• 95mm wide (ODAS width) - 55mm depth matches other ODAS cards ODAS-PSOC5 (Rev X3 or higher), DIGIO32-I2C, etc
• 6-32 mounting holes
• 0.1" pitch connector, 2x20 pins, Connector could be mounted to the front or rear of the card
• (8) Ground pins (common ground)
• 3mm LEDs

Series resistor - let us know what value you want

• Series Resistor Values
• Pick a series resistor value assuming the LED forward voltage is about 2V.
• Operating with 3.3V will require a smaller resistance than operating at 5V for the same current.
• Standard series resistor values we carry are: 120, 150, 200, 220, 240, 270, 330, 470, 560, and 1K.
• For 5V operation and not too bright LED (comfortable value for front panels) we use 560 ohms.
• With 3V across 560 ohms that's only 5 mA (for 560 ohm resistor). For something with a lot of LEDs if they are too bright it can get annoying.

Test Procedure

Setup

• PiPicoMite02 Based Test Station
  • PiPicoMite02 Processor card
• LED-32 - Unit Under Test (UUT)
• DB37RIBBON plugged into UUT
• (2) of 2x10 cables to connect between DB37RIBBON and UUT
  • DB37-1 marked on cable end goes near P1 marked on DB37RIBBON
• LED32-1 marked on cable end goes near HDR1 marked on UUT

Card Test Procedure

• Power up Test Station/UUT
• Type

chdir "/lbcards/GPIO32"
load " GPIO32-01.bas"
run

• Should see the LEDs go around the UUT card
• Hit any key to stop (after finishing rotation)

Pinout

HDR1 pin	LED		HDR1 pin	LED
1	GND		2	GND
3	GND		4	GND
5	D0		6	D16
7	D1		8	D17
9	D2		10	D18
11	D3		12	D19
13	D4		14	D20
15	D5		16	D21
17	D6		18	D22
19	D7		20	D23
21	D8		22	D24
23	D9		24	D25
25	D10		26	D26
27	D11		28	D27
29	D12		30	D28
31	D13		32	D29
33	D14		34	D30
35	D15		36	D31
37	GND		38	GND
39	GND		40	GND

Assembly Sheet

• LED-32_Assembly_Sheet