Difference between revisions of "WA3TFS SDR Upverter Design"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 20: | Line 20: | ||
=== Pass Filter === | === Pass Filter === | ||
| + | |||
| + | [[file:WA3TFS_Upverter_Inductor.PNG]] | ||
[[file:WA3TFS_Upverter_Pass_Filter.PNG]] | [[file:WA3TFS_Upverter_Pass_Filter.PNG]] | ||
Revision as of 13:23, 14 October 2021
Contents
Features
SDR up-converter/receiver shifts low frequencies up by 100 MHz. Used to listen to HF frequencies on an inexpensive RTL-SDR module.
- $55 at W3PIE hamfest
- SBL-1 mixer
- 100 MHz can oscillator
- Low pass filter
- 1 kHz to 1.7 GHz SDR Receiver - WA3TFS Design
Schematic
Pass Filter
Software
Build
- Nice silver mica caps
- My kit was missing the center cap of the band filter (150 pF)
- SBL-1 mixer
- 30pF cap installed in J_A to J_B marked 300
- Build was tough due to very small pads on the PCB
- Particularly tough to solder ground pads
- Pad shapes were not round so less area to set soldering iron
- Pin 1 orientations on the mixer and oscillator "backwards" from other board legends
- Pin 1 shown in red
Wiring
Enclosure
- Board fits perfectly in
- Extruded Aluminum Enclosure Box - 94mm x 83mm x 30mm
- Card just perfectly matches
Videos by others
