Difference between revisions of "DigIO16-I2C"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 64: | Line 64: | ||
=== Arduino === | === Arduino === | ||
| − | * [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_MCP23017 Driver code] | + | * [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_MCP23017 LandBoards_MCP23017 Driver code] |
| − | * [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_MCP23017/examples/PROTO16I2CBlink Example code] | + | * [https://github.com/land-boards/lb-Arduino-Code/tree/master/libraries/LandBoards_MCP23017/examples/PROTO16I2CBlink LandBoards_MCP23017 Example code] |
=== Raspberry Pi === | === Raspberry Pi === | ||
Revision as of 16:48, 7 April 2022
Features
- 16 bit GPIO
- MCP23017 I2C Parallel I/O
- I2C host interface
- 100/400 KHZ operation
- 25mA sink/source capability per I/O
- Jumper selectable terminators
- 3-bit address (Jumper selectable) - Up to 8 boards
- I2C Connector
- Daisy-chained 4-pin host interface connector (Ground, Power, Clock, Data)
- Power Connector
- DB-25 Connector for GPIO lines
- 24LC024 Personality EEPROM
- 3.3V or 5V operation
- Compatible with Arduino, Raspberry Pi, BeagleBone Black
- 95x95mm form factor
- (4) 6-32 mounting holes - one on each corner
Connectors
J1 - Power Connector (Optional)
J2, J3 - Daisy-chained I2C Connectors
J4 - Address Base Jumpers
- Install for address bit = 0
J5 - Interrupt/Card Present
J6 - I2C Terminators
J7 - Write Enable Jumper
- Install to enable writes
J8 - DB-25F I/O connector
