Difference between revisions of "SYNTH-VCO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 4: | Line 4: | ||
* Build of [https://note.com/solder_state/n/nca6a1dec3921 Pico VCO by HAGIWO] | * Build of [https://note.com/solder_state/n/nca6a1dec3921 Pico VCO by HAGIWO] | ||
| − | * Digital VCO | + | * Digital Voltage Controlled Oscillator (VCO) |
| − | * | + | * Three modes: Wavefold, FM and AM |
| + | * PWM output with 2 pole low pass filter | ||
* Each mode has eight built-in waveforms | * Each mode has eight built-in waveforms | ||
* XIAO RP2040 controller | * XIAO RP2040 controller | ||
Revision as of 13:46, 23 September 2022
Features
- Build of Pico VCO by HAGIWO
- Digital Voltage Controlled Oscillator (VCO)
- Three modes: Wavefold, FM and AM
- PWM output with 2 pole low pass filter
- Each mode has eight built-in waveforms
- XIAO RP2040 controller
- Standard EuroRack 16 pin header
- Supports 12V in with on-board 5V regulator
- 5V regulator can be not installed if 5V is available on EuroRack connection
- Card is not a Eurorack card
- Probably too deep, needs cabling
- (4) 6-32 mounting holes
- Stacks with SYNTH-MIDI-CTL-01 card
