Difference between revisions of "SYNTH-VCO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 23: | Line 23: | ||
* (4) 6-32 mounting holes | * (4) 6-32 mounting holes | ||
** Stacks with [[SYNTH-MIDI-CTL-01]] card | ** Stacks with [[SYNTH-MIDI-CTL-01]] card | ||
| + | |||
| + | == Software == | ||
| + | |||
| + | * [https://github.com/land-boards/lb-boards/blob/master/Audio%20Cards/SYNTH-VCO-01/SOFTWARE/SYNTHVCO01/SYNTHVCO01.ino SYNTHVCO01 Arduino Code] | ||
Revision as of 14:27, 23 September 2022
Features
- Build of Pico VCO by HAGIWO
- Digital Voltage Controlled Oscillator (VCO)
- Three modes: Wavefold, FM and AM
- PWM output with 2 pole low pass filter
- Each mode has eight built-in waveforms
- XIAO RP2040 controller
- (5) Pushbuttons
- Octave Up/Down
- Mode Up/Down (Wavefold, FM and AM)
- Push Timbre
- (2) Knobs
- Freq fine adjust
- Mod adjust
- Standard EuroRack 16 pin header
- Supports 12V in with on-board 5V regulator
- 5V regulator can be not installed if 5V is available on EuroRack connection
- Card is not a Eurorack card
- Probably too deep, needs cabling
- (4) 6-32 mounting holes
- Stacks with SYNTH-MIDI-CTL-01 card
