Difference between revisions of "ER-PROTO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 33: | Line 33: | ||
=== Inter-card Connectors === | === Inter-card Connectors === | ||
| + | |||
| + | * J5 is on both Controls and the I/O card | ||
[[file:ER-PROTO-CTLS-6-01_J5.PNG]] | [[file:ER-PROTO-CTLS-6-01_J5.PNG]] | ||
| + | |||
| + | * J6 on the controls card is J37 on the I/O card | ||
[[file:ER-PROTO-CTLS-6-01_J10.PNG]] | [[file:ER-PROTO-CTLS-6-01_J10.PNG]] | ||
Revision as of 22:01, 25 October 2022
Features
- Eurorack Prototyping card set
- 6 HP wide (30mm) front panel
- 3U tall
- Three card set
- Board interconnect headers duplicated on headers
- 30mm wide front panel
- 28mm wide panel and daughtercards
- 6 POTS
- Marked as RV1-RV5
- Series resistors on pot wiper
- All 3 pot pins brought to top header
- 4 Jacks
- Marked as J1-J4
- Tip/sleeve brought to header near middle/bottom
- Pots on top, jacks on bottom of card
- Easier to adjust pots without bumping into pots
- Pots more often accessed than jacks
- Large prototyping area
- 58 nodes with 3 holes per node (29 per "side")
- +12V, -12V down board edges
- 5V/GND down center of card
- Bussed connections horizontally
- Front Panel with generic labels
- Cover with White on Black P-Touch labels
Connectors
- J1-J4 are front panel connectors
Inter-card Connectors
- J5 is on both Controls and the I/O card
- J6 on the controls card is J37 on the I/O card
Example
- Arduino NANO with quad Opamp example
