ER-PROTO-01

Features

• Eurorack Prototyping card set
• 6 HP wide (30mm) front panel
• 3U tall
• Three card set
  • Board interconnect headers duplicated on headers
  • 30mm wide front panel
  • 28mm wide panel and daughtercards
• 6 POTS
  • Marked as RV1-RV5
  • Series resistors on pot wiper
  • All 3 pot pins brought to top header
• 4 Jacks
  • Marked as J1-J4
  • Tip/sleeve brought to header near middle/bottom
• Pots on top, jacks on bottom of card
  • Easier to adjust pots without bumping into pots
  • Pots more often accessed than jacks
• Large prototyping area
  • 58 nodes with 3 holes per node (29 per "side")
• +12V, -12V down board edges
• 5V/GND down center of card
• Bussed connections horizontally
• Front Panel with generic labels
  • Cover with White on Black P-Touch labels

Connectors

• J1-J4 are front panel connectors

Inter-card Connectors

Pots

• J5 on the Controls card and J5 on the I/O card
• Pot connections
  • POTx-1 is fully CW connects to wiper
  • POTx-2 is wiper
  • POTX-3 is fully CCW connects to wiper

• To make pot into voltage control
  • POTx-1 (CW) = +5V
  • POTx-13CCW = GND
  • Wire RV1-1 to RV3-1 to RV5-1 on controls card
  • Wire RV1-3 to RV3-3 to RV5-3 on controls card
  • Wire RV2-1 to RV4-1 to RV6-1 on controls card
  • Wire RV2-3 to RV4-3 to RV6-3 on controls card

Jacks

• J6 on the controls card and J37 on the I/O card

Daughtercard Connectors

J5, J37 - POT connectione

J6 - Eurorack Power

• J6 on the I/O card
  • Eurorack power
  • 2x5 IDC
  • GATE, CV not connected

J10 - Jacks connections on Controls card

J38 - Jacks connections

Examples

Arduino NANO MOZZI

Arduino NANO MOZZI on ER-PROTO-01

CV4 - 4 Control Voltages

CV4 on ER-PROTO-01

Slew Rate Controller

Slew Rate Controller on ER-PROTO-01

Noise Generator

Noise Generator on ER-PROTO-01