Difference between revisions of "Signal Generator"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
== Signal Generator from Stuff I've Already Made == | == Signal Generator from Stuff I've Already Made == | ||
| − | * [[NewPot2]] | + | * [[NANO-BKOUT]] |
| + | ** Probably don't need all the connectors, but why not just install them? | ||
| + | * 5V Power Regulator | ||
| + | ** USB connector | ||
| + | * 2x [[NewPot2]] | ||
** Used as 0.1" pitch connector to Encoders | ** Used as 0.1" pitch connector to Encoders | ||
** Install R1-R3 = 10K | ** Install R1-R3 = 10K | ||
Revision as of 13:22, 7 September 2020
Signal Generator from Stuff I've Already Made
- NANO-BKOUT
- Probably don't need all the connectors, but why not just install them?
- 5V Power Regulator
- USB connector
- 2x NewPot2
- Used as 0.1" pitch connector to Encoders
- Install R1-R3 = 10K
- Don't install ATTiny85
- Don't install C1
- Don't install D/A converter
- PulseGen
- Use to drive square wave on BNC to 50 Ohm load
- Install BNC, 74AC14, 249 Ohm Series resistors
- Don't install oscillator parts
