Difference between revisions of "FTDI-49MM"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 12: | Line 12: | ||
** Mounts to 95mm to 45mm adapter | ** Mounts to 95mm to 45mm adapter | ||
** Stacks up with standoffs for use with other 95mm cards | ** Stacks up with standoffs for use with other 95mm cards | ||
| + | |||
| + | == Headers/Jumpers == | ||
| + | |||
| + | === 5V/3.3V Jumper === | ||
| + | |||
| + | * Select 5V or 3.3V signal levels on FTDI connector | ||
| + | * 5V out on FTDI connector VCC pin | ||
| + | |||
| + | === FDTI Connector === | ||
| + | |||
| + | # GND | ||
| + | # CTSn | ||
| + | # VCC | ||
| + | # TX | ||
| + | # RX | ||
| + | # RTSn | ||
== Stackup with EP2 FPGA card == | == Stackup with EP2 FPGA card == | ||
Revision as of 11:11, 2 October 2020
Contents
Features
- FT230X USB-to-FTDI Serial IC
- USB B connector (not micro or mini, but the beefy USB B connector)
- FTDI compatible pinout
- 3.3V or 5V selection jumper
- Header for 5V power distribution
- Rx and Tx LEDs
- (4) 4-40 mounting holes
- Mounts to 95mm to 45mm adapter
- Stacks up with standoffs for use with other 95mm cards
Headers/Jumpers
5V/3.3V Jumper
- Select 5V or 3.3V signal levels on FTDI connector
- 5V out on FTDI connector VCC pin
FDTI Connector
- GND
- CTSn
- VCC
- TX
- RX
- RTSn
Stackup with EP2 FPGA card
- Top to bottom of stackup
- EP2C5-DB
- Cyclone_II_EP2C5_Mini_Dev_Board Card
- FTDI-49MM - (this card)
- CARRIER95TO49MM
Pinout
- GND
- CTS* (in)
- VCC
- TX (out)
- RX (in)
- RTS* (out)
