Difference between revisions of "DigIO16-I2C"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 10: | Line 10: | ||
** 100/400 KHZ operation | ** 100/400 KHZ operation | ||
** 25mA sink/source capability per I/O | ** 25mA sink/source capability per I/O | ||
| − | * Jumper selectable terminators | + | * Jumper selectable I2C terminators |
* 3-bit address (Jumper selectable) - Up to 8 boards | * 3-bit address (Jumper selectable) - Up to 8 boards | ||
* I2C Connector | * I2C Connector | ||
Revision as of 20:18, 31 May 2022
Features
- 16 bit GPIO
- MCP23017 I2C Parallel I/O
- I2C host interface
- 100/400 KHZ operation
- 25mA sink/source capability per I/O
- Jumper selectable I2C terminators
- 3-bit address (Jumper selectable) - Up to 8 boards
- I2C Connector
- Daisy-chained 4-pin host interface connector (Ground, Power, Clock, Data)
- Power Connector
- DB-25 Connector for GPIO lines
- 24LC024 ODAS Personality EEPROM
- pid = 1
- 3.3V or 5V operation
- Compatible with Arduino, Raspberry Pi, BeagleBone Black
- 95x95mm form factor
- (4) 6-32 mounting holes - one on each corner
Connectors
J1 - Power Connector (Optional)
J2, J3 - Daisy-chained I2C Connectors
J4 - Address Base Jumpers
- Install for address bit = 0
J5 - Interrupt/Card Present
J6 - I2C Terminators
J7 - Write Enable Jumper
- Install to enable writes
J8 - DB-25F I/O connector
