Difference between revisions of "DRIVE50"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 3: | Line 3: | ||
== 50 Ohm Driver Card == | == 50 Ohm Driver Card == | ||
| − | * Line driver | + | * Line driver "TTL" Level |
* 50 or 75 Ohm output impedance | * 50 or 75 Ohm output impedance | ||
| + | * BNC or SMA output connector | ||
* 10K pull-up on input | * 10K pull-up on input | ||
* Card is non-inverting | * Card is non-inverting | ||
| − | |||
* 3V-5V power | * 3V-5V power | ||
* 3-pin right angle 0.1" pitch input connector | * 3-pin right angle 0.1" pitch input connector | ||
Revision as of 16:08, 6 July 2022
50 Ohm Driver Card
- Line driver "TTL" Level
- 50 or 75 Ohm output impedance
- BNC or SMA output connector
- 10K pull-up on input
- Card is non-inverting
- 3V-5V power
- 3-pin right angle 0.1" pitch input connector
- (4) 4-40 mounting holes
Driver
- 5x paralleled 74AC14 drivers
- 24mA per pin
- Schmitt Trigger Input
- Input has single buffer stage
- 3.3V, 250 Ohm resistors (/5) for 50 Ohm output
- Short-circuit proof
- 5V, 250 Ohms to ground is 20 mA (pins are rated for 24 mA
- Normal output = 10 mA per pin
Test
- Supply Vcc 3.3V to 5V and ground
- Input is pulled up to Vcc
- Measure output with BNC T
- Should be 1/2 of Vcc with 50 Ohm terminator
- Should be Vcc without terminator
Mechanicals
