Difference between revisions of "DRIVE50"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) (→Driver) |
Blwikiadmin (talk | contribs) (→Driver) |
||
| Line 16: | Line 16: | ||
* 5x paralleled [http://cva.stanford.edu/classes/cs99s/datasheets/74AC14.pdf 74AC14] drivers | * 5x paralleled [http://cva.stanford.edu/classes/cs99s/datasheets/74AC14.pdf 74AC14] drivers | ||
** 24mA per pin max current output | ** 24mA per pin max current output | ||
| + | *** Symmetric high-low drive levels | ||
** Short-circuit proof | ** Short-circuit proof | ||
*** 5V, 250 Ohms to ground is 20 mA (pins are rated for 24 mA | *** 5V, 250 Ohms to ground is 20 mA (pins are rated for 24 mA | ||
Revision as of 17:12, 6 July 2022
50 Ohm Driver Card
- "TTL" Level Line driver
- 50 or 75 Ohm output impedance
- BNC or SMA output connector
- 10K pull-up on input
- Card is non-inverting
- 3V-5V power
- 3-pin right angle 0.1" pitch input connector
- (4) 4-40 mounting holes
Driver
- 5x paralleled 74AC14 drivers
- 24mA per pin max current output
- Symmetric high-low drive levels
- Short-circuit proof
- 5V, 250 Ohms to ground is 20 mA (pins are rated for 24 mA
- 24mA per pin max current output
- Schmitt Trigger Input
- Input has single buffer stage
- 3.3V, 250 Ohm resistors (/5) for 50 Ohm output
- Normal output = 10 mA per pin
Test
- Supply Vcc 3.3V to 5V and ground
- Input is pulled up to Vcc
- Measure output with BNC T
- Should be 1/2 of Vcc with 50 Ohm terminator
- Should be Vcc without terminator
Mechanicals
