Difference between revisions of "Signal Generator"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
== Signal Generator from Stuff I've Already Made == | == Signal Generator from Stuff I've Already Made == | ||
| − | * [[NANO-BKOUT]] | + | * [[NANO-BKOUT]] - Arduino NANO Breakout board |
** Probably don't need all the connectors, but why not just install them? (Good for 5V power/ground distribution) | ** Probably don't need all the connectors, but why not just install them? (Good for 5V power/ground distribution) | ||
** 5V Power Regulator | ** 5V Power Regulator | ||
Revision as of 13:25, 7 September 2020
Signal Generator from Stuff I've Already Made
- NANO-BKOUT - Arduino NANO Breakout board
- Probably don't need all the connectors, but why not just install them? (Good for 5V power/ground distribution)
- 5V Power Regulator
- USB connector
- 2x NewPot2
- Used as 0.1" pitch connector to Encoders
- Install R1-R3 = 10K
- Don't install ATTiny85
- Don't install C1
- Don't install D/A converter
- PulseGen
- Use to drive square wave on BNC to 50 Ohm load
- Install BNC, 74AC14, 249 Ohm Series resistors
- Don't install oscillator parts
NANO-BKOUT
