NanoVNA

NanoVNA - Network Analyzer

Specifications

• Number of Calibration Points: 101 (Fixed)
• Number of Scanning Points: 101 (Fixed)
• Display Tracking: 4, Marking: 4, Save Setting : 5
• PCB: 54mm x 85.5mm x 11mm (without the size of connectors, switches)
• Measurement Frequency: 50KHz ~ 300MHz (50KHz -900MHz, enable extended firmware)
• RF Output: -13dbm (maximum -9dbm)
• Frequency Accuracy: 0.5ppm
• Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
• Port SWR: 1.1
• Display: 2.8 inch TFT (320 x240)
• USB Interface: USB Type-C; Communications Mode: CDC (Serial)
• Power Supply: USB 5V 120mA, built-in 400mAh electricity, maximum charging current 0.8A
• nanovna users nanovna-users@groups.io
• Amazon links

Adding a battery

• My unit did not come with a battery
• Added an SMT mount ST connector to the board
• Added an 850 mAh LiPo battery
• The pinout on the card was backwards from the pinout of the connector at the end of the battery wires
  • Removed the pins from the battery wire connector and flipped the pins
• Charging works
• Battery is a bit too thick to screw the back on completely
• Switched to longer standoffs
• Someone else's page (they added an inline connector and wired to the card)
  • Adding a battery

Software

• NanoVNA Saver
• Google Drive
• User Group