Difference between revisions of "Frequency Calibration via GPS"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) (→FTDI) |
||
| Line 36: | Line 36: | ||
=== FTDI === | === FTDI === | ||
| − | * [[FTDI-49MM]] | + | * [[FTDI-49MM]] USB to serial interface |
| + | * U-Center communicates with the GPS over this interface | ||
| + | * Tx/Rx LEDs | ||
| + | * 49x49mm | ||
=== 50 Ohm Driver (Not Required - nice to have) === | === 50 Ohm Driver (Not Required - nice to have) === | ||
Revision as of 11:21, 22 December 2020
Inexpensive Frequency Standard with output synchronized to GPS satellites,
Contents
Features
- Generates very accurate frequency output
- U-Blox NEO-7M GPS Module
- Remote Amplified GPS Antenna
- FTDI-49MM
- 50 Ohm Output
- Metal enclosure
Parts
GPS
- U-Blox NEO-7M GPS Module
- Programmable frequency from USB
- SMA Female connector
- 5V operation
U-Center Programming Software
- TP5 sets PPS output to "any" frequency
- U-Blox website
- Set to 8 MHz on GPS PPS pin when locked
- Other frequencies have some "jitter" but are still GPS accurate
- Set to 2 Hz on GPS PPS pin when not locked
FTDI
- FTDI-49MM USB to serial interface
- U-Center communicates with the GPS over this interface
- Tx/Rx LEDs
- 49x49mm
50 Ohm Driver (Not Required - nice to have)
- Used modified PulseGen card to drive 50 Ohms, 5V level output
- Remove oscillator circuit
- 5 parallel 74AC14 outputs with 249 ohm resistors on each output
- Able to drive long 50 ohm coax
- Square wave output
- Very fast edges
Videos
- This is the approach I followed
- GPSDO vs Rubidium Frequency Standard
